4-Channel Transmit Module with Patch Antenna for 5G Application

Comments

Post a Comment

Popular posts from this blog

Image
Slotted Waveguide Array Antenna Slotted antenna arrays used with waveguides are a popular antenna in navigation, radar, and other high-frequency systems. A waveguide is a very low loss transmission line. It allows propagating signals to a number of smaller antennas (slots). Each of these slots allows a little of the energy to radiate. Slot impedance and resonant behavior for a single slot are dependent on slot placement and size. Its exceptional directivity in the elevation plane gives it quite high power gain. The slotted waveguide has achieved most of its success when used in an omnidirectional role To make the unidirectional antenna radiate over the entire 360 degrees of azimuth, the second set of slots are cut on the back face of the waveguide. An 8×8 planar four pole X-band Tchebyshev dual inductive post substrate integrated waveguide filter from 10.15 GHz to 10.7 GHz is designed for terrestrial broadcasting. The filter is designed on the 5870 with a relative dielectric
Read more

Dual Channel Rotary Joint

Image
A Rotary Joint (RJ) is a wide spread microwave device that is used to change the direction of microwave propagation between two waveguides by rotating one with respect to another. Rotary joints find many applications in radar and satellite earth stations for functions such as polarization rotation; antenna feed systems and azimuth and elevation motions. Many styles of rotary joints are available for a variety of environmental conditions. Multichannel rotary joints must be carefully designed to achieve low channel loss and small rotational variations of this loss.   A n investigation was first carried out to review the state of the art in the field of multiple-channel rotary joints and to select the types of propagation modes that best satisfied the special system needs. A review of possible design approaches led to the selection of a concentric coaxial line configuration for the main body of the rotary joint, with integral transitions to waveguide at both ends for minimum over
Read more

QFN Package Simulation

Image
he Quad Flat No-lead (QFN) package is a CSP (plastic encapsulated package) with a copper lead frame substrate. QFN type package is one of the most cutting-edge IC packaging technologies in the electronics. The QFN is a leadless package where electrical contact to the PCB is made by soldering the leads on the bottom surface of the package to the PCB, instead of the conventional formed perimeter gull wing leads. The QFN-type package is known for its small size, cost-effectiveness and good production yields. QFN also possess certain mechanical advantages for high-speed circuits including improved co-planarity and heat dissipation. The QFN has pins on 4 edges of the bottom surface of the package. The QFN can have either a square or rectangle body as well as symmetric or asymmetric terminal patterns. The QFN was introduced to replace the gull wing lead Quad Flat Package (QFP) because the component leads are embedded in the plastic and cannot be bent during handling to insure consistent
Read more